| Make Your Own Needle Clamp |
|
|
| Written by Reader Submitted | |
| Thursday, 15 May 2008 | |
|
How-to Article...by Marc Weijenberg  A quick step-by-step article on how to make your own clamp for securing the High and Low speed needles on your carburetor. I had been pondering about a carb needle fixture for some time now, to stop the needles from re-adjusting themselves. Well, had an idea that I would like to share with everyone. Step 1 Get a couple of bigger type cable connectors (match size to carb needle)  Step 2 Cut them open and remove the parts  Step 3 Clean them and grind them to size (if needed)  Step 4 Solder them together and clean them up  Step 5 Mount the item   Marc W. |
|
| Last Updated ( Thursday, 06 November 2008 ) |
You need to login or register to post comments.
Discuss this item on the forums. (0 posts)
