New from GasRCProducts

thumb_DSCN4626
New products from Gas RC Products...






Here is a look at a few new products out by Gas RC Products. For more info on these products and up-to-date pricing please visit their website.





DSCN4617 DSCN4618

Exhaust Outlet: All CNC machined. Great for hulls like Thunderboats that have a completely enclosed exhaust system inside the boat. I.D. is .550". O.D. at threaded section is about .700". Installs just like a typical bulkhead fitting. Drill hole, install outlet from outside the hull and secure from inside with the nut.


DSCN4620 DSCN4621

Coil Relocator: keeps coil low on engine and coil wire out of the way of bellcrank system. Comes with stainless mounting hardware.


DSCN4622 DSCN4623

Servo Bracket: For standars size servos. These all are quite similar really. The thing I like alot about this new one from GasRCProducts is the fact that the mounting bolts supplied are small enough that you can use the rubber isolators AND the brass inserts that come with the servos.


DSCN4624

Stuffing Tube Clamp: This is a very nice clamp. Use it to keep the 5/16" stuffing tube from moving/sliding inside the 11/32" sleeve.


DSCN4625

Throttle Arm: CNC machined. This arm is sized to fit carburetors with a 3/16" shaft such as the very popular WT-257 from Walbro. Notice the set-screw placement...this makes this carb arm VERY easy to install and remove while the carburetor is on the engine. A very nice touch!








A few not-so-new products from GasRCProducts that are worth checking out...

DSCN4299 DSCN4300

Billet Radiobox Seal Mounts: no more need for glue! Simply drill the box, insert the mounts and tighten them securely in place with the included nut. The outside of the seal mount has an Oring to create a water-proof seal against the radio box. Then simply slide the bellows pushrod seal over the mount's barbed niple and you're done! Easy to install and more importantly, easy to replace worne out rubber seals!



DSCN4301

Billet IV Bag Fitting: this is an aluminum hi-flow fitting to adapt your fuel line to your IV bag setup. It has a 1/8" inside bore diameter and features a barbed end for the gas line. The smooth end goes inside the bag and the section with the grooves is where you ziptie the bag to the fitting. Notice the smooth finish that will not damage the IV bag.



DSCN4302

Thru-Transom Water Exits: Add a nice touch to your builds with these billet thru-transom exits. Drill the transom and glue these in place, then simply run the water line through them. Makes for a nice clean look.

User Login

Mailbox

You are not logged in.

© 2017 Modelgasboats.com. All Rights Reserved.