RE: Zenoah Motor Question

More
16 years 5 months ago #11281 by usttraw
Zenoah Motor Question was created by usttraw
Ok... I'm new again... so my technical lingo in not up to speed. I have a 2009 CC Pro Mod purchased from the dock (Carlo confirmed it) that had as listed couple of weekends use. Visually it's mint. Question... when holding the collet, you can move the shaft in and out a little. Is this type of play normal? Thanks!!!!

Please Log in or Create an account to join the conversation.

More
16 years 5 months ago #11282 by GHill
Replied by GHill on topic RE: Zenoah Motor Question
Yes you need the end play, not sure how much but i know it is to be there.


Graham

Please Log in or Create an account to join the conversation.

  • Scott
  • Offline
  • Devoted Enthusiast ... MGB Technical advisor
More
16 years 5 months ago #11283 by Scott
Replied by Scott on topic RE: Zenoah Motor Question
Yep, .020" or so of In and out is typical.
2 stroke Engine Tech of 30+ years, Prop tweeker, Chronic tinkerholic, Home of Motor Heads RC Racing Engines ...
8 time NAMBA National 6 lap heat racing record holder.

Please Log in or Create an account to join the conversation.

More
16 years 5 months ago #11285 by marc
Replied by marc on topic RE: Zenoah Motor Question
As Scott said...about 10-20 thou is normal...when you don't feel any end play at all is when you start to look closer at things!!! Using the wrong bearings and or gaskets can cause the endplay to be insufficient and cause problems. :)
Modelgasboats.com - Home of the WARPATH Riggers!

Follow Modelgasboats.com on FACEBOOK - CLICK HERE
"

Please Log in or Create an account to join the conversation.

More
16 years 5 months ago #11312 by usttraw
Replied by usttraw on topic RE: Zenoah Motor Question
Ok... I feel better now! Thanks!

PS> Marc, check out my XXX build status on the dock... getting closer!

Please Log in or Create an account to join the conversation.

Time to create page: 0.157 seconds

Main Menu