Con rod pin snap rings

More
15 years 11 months ago - 15 years 11 months ago #13025 by 315neil1007
Con rod pin snap rings was created by 315neil1007
What's the easiest way to put in the 2 snap rings on the side of the piston? I don't have a spare clip, and I don't want to bend the clip. Better to ask than to break it. I am kinda new to this site,BUT I Just found the Jesus Clip article, Thanks Scott for the nicely informative article. My eyes are hard to find them little devils. I better read some more tips & teck articles
Last edit: 15 years 11 months ago by 315neil1007.

Please Log in or Create an account to join the conversation.

  • Scott
  • Offline
  • Devoted Enthusiast ... MGB Technical advisor
More
15 years 11 months ago #13081 by Scott
Replied by Scott on topic Re:Con rod pin snap rings
Just found this post ... Your welcome
Yes those Hey Zuse clips can be a bear if not having quality SMALL tip needle nose pliers or that tool.
2 stroke Engine Tech of 30+ years, Prop tweeker, Chronic tinkerholic, Home of Motor Heads RC Racing Engines ...
8 time NAMBA National 6 lap heat racing record holder.

Please Log in or Create an account to join the conversation.

More
15 years 11 months ago #13094 by 315neil1007
Replied by 315neil1007 on topic Re:Con rod pin snap rings
We took out my EasyVee for a 1st test run Sunday. First pull on the startup.We all had a fun day.She ran a little loose. Trim tab need some attention & drop down some. I kept bending my bellcrank & slip past the carb arm. We did get it right some playing around. I think I like the other carb arm setup. We ran & ran & ran.
[img
Attachments:

Please Log in or Create an account to join the conversation.

Time to create page: 0.141 seconds

Main Menu