To Lean?

I have a JnG 25.6 with a wyk carb. When I give it full throttle(not under load) it sort of pulsates and spits some gas out the carb.

To Lean? to rich?

Sounds too rich to me. WYK will spit a bit anyway at low rpm.

Where are your needles. The needle in the barrel I used to run at 7 - 7 1/2 turns and remeber the high, think around 1 1/2 or 2 turns. On a QD so settings should be similar.

QDRevenger.

Hey QD,

Thanks for the tip. The side screw is set at 1 1/2 turns. I cant find my small set of screwdrivers that will fit down the little hole in the top of the carb Ill let you know where it is set after testing.

Thanks again

Piratefish

Problem resolved 7 1/2 turns

Thanks QD

piratefish

Good stuff

I found my notes and you were bang on with the main needle. 1 1/2 was where I had mine.

QDRevenger.