Making custom exhaust

sparky379 wrote:

well,, that just bites,,,i will have to live with the loss of power, because thats the look I am after,, the 4 scaled exhausts sticking out the back,,, I mean,, I dont race it, i am the only one for 70 miles with a boat,, i just want the look, i dont mind sparing on the performance a bit,,,

I'm one of a very few where I live .... but I still want both ...looks and speed .... read what Marc and Scott are telling u ... u can do both I have in past exactly the way Marc describes

you can even take it one set further and i put one water outlet into exhaust manifold (not tuned pipe) and have dual exhaust with water (which also stops exhaust heat from burning boat ... I'm just a sport boat guy through

Read it again m8...


Randy
good luck

see attached ... if it works

sorry pic won't post

Heres how my old mate Wayne did it on his dads cat,the quad outlets and exhaust were custom built.If your using stock motors you wont notice much if any loss over a tuned pipe setup.That said you could probably incorporate a tuned pipe into the setup if you have the room.
Mart

Arrow Shark does make a dual exhaust outlet pipe that fits on end of your exhaust

look on eBay several places sell them for around
$$ 38.00us

Randy

Wouldnt be hard to make it into a quad exhaust if you can weld or silver solder stainless steel.
Mart

check under MGB Building and Construction 'help with my exhaust' I posted couple ideas for u

Randy

Inject some water for even more realism.

The exhaust I;m refering too in building comes off a WGG 'wet exhaust' so it already has water



it's a pretty cool boat and set up watch his video

Randy

here is pic

randy [