- Posts: 6
- Thank you received: 0
gaskets
- Twoolley08
-
Topic Author
- Offline
Less
More
16 years 8 months ago #9202
by Twoolley08
gaskets was created by Twoolley08
hey I have a brand new rcmk never been ran. If I take it apart will i need to put new gaskets on or will they be fine?
Please Log in or Create an account to join the conversation.
- Scott
-
- Offline
- Devoted Enthusiast ... MGB Technical advisor
Less
More
- Posts: 1254
- Thank you received: 23
16 years 8 months ago #9204
by Scott
2 stroke Engine Tech of 30+ years, Prop tweeker, Chronic tinkerholic, Home of Motor Heads RC Racing Engines ...
8 time NAMBA National 6 lap heat racing record holder.
Replied by Scott on topic Re:gaskets
If un-torn, and you put back in place at original orientation, no problem generally
2 stroke Engine Tech of 30+ years, Prop tweeker, Chronic tinkerholic, Home of Motor Heads RC Racing Engines ...
8 time NAMBA National 6 lap heat racing record holder.
Please Log in or Create an account to join the conversation.
- Moofy07
-
- Offline
Less
More
- Posts: 453
- Thank you received: 0
16 years 8 months ago #9205
by Moofy07
Replied by Moofy07 on topic Re:gaskets
Hi,
Some people keep the originals, but they are so fragile especially if the gaskets are not in the exact position they were before refit. I have always replaced them when I change something or everything in the engines. (compared to the cost of a new engine it is cheap insurance)
Hope this helps.:bye:
Some people keep the originals, but they are so fragile especially if the gaskets are not in the exact position they were before refit. I have always replaced them when I change something or everything in the engines. (compared to the cost of a new engine it is cheap insurance)
Hope this helps.:bye:
Please Log in or Create an account to join the conversation.
- Twoolley08
-
Topic Author
- Offline
Less
More
- Posts: 6
- Thank you received: 0
16 years 8 months ago #9206
by Twoolley08
Replied by Twoolley08 on topic Re:gaskets
whole sells complete gasket kits?
Please Log in or Create an account to join the conversation.
Time to create page: 0.135 seconds