- Posts: 12
- Thank you received: 0
rev question
- petdos
-
Topic Author
- Offline
Less
More
16 years 7 months ago #9912
by petdos
rev question was created by petdos
Hi to all,just finding out weather this is normal or there is something wrong,motor idles fine, slow acceloration to top speed fine, back off slow no problem,go straight to flat out fine also ,but let go of throttle motor dies,do i need to up the idle trim more or is there acctually something wrong,thanks for any imput.
Please Log in or Create an account to join the conversation.
- marc
-
- Offline
Less
More
- Posts: 2491
- Thank you received: 55
16 years 7 months ago #9917
by marc
"
Replied by marc on topic RE: rev question
When you say it idles fine at first....are you holding throttle for it to idle? Sounds to me like you just need to trim a little bit more idle in your radio. Are you testing on water or on the bench?
"
Please Log in or Create an account to join the conversation.
- petdos
-
Topic Author
- Offline
Less
More
- Posts: 12
- Thank you received: 0
16 years 7 months ago #9924
by petdos
Replied by petdos on topic RE: rev question
Hi,idle is set at trim(probably not enough about 1/2 way)and test on both water and bench,thanks
Please Log in or Create an account to join the conversation.
- marc
-
- Offline
Less
More
- Posts: 2491
- Thank you received: 55
16 years 7 months ago #9925
by marc
"
Replied by marc on topic RE: rev question
Set your idel with the radio trim (do not use the idle screw on carb if equipped with one - just remove it) and see if it's ok.
"
Please Log in or Create an account to join the conversation.
- petdos
-
Topic Author
- Offline
Less
More
- Posts: 12
- Thank you received: 0
16 years 7 months ago #9927
by petdos
Replied by petdos on topic RE: rev question
Thanks heaps,peter.
Please Log in or Create an account to join the conversation.
Time to create page: 0.149 seconds