This thread discusses the Content article: Setup Board

I just made mine from a sink cutout from a formica counter top, cost was two dollars at the cabinet store!! dimensions are 31 x 20 and has a smooth formica surface on one side.
I plan to screw some boards vertical on the bottom as you did to keep it up off the table or whatever it sat upon..


mike sr

That will definitely work! The verticals also will prevent it from sagging over time.

Hey.. Need get the XRumer 7.5.31
Or maybe for payment. Anybody sell? I can pay with Western Union!

Hope for answer

How about a few photos of the different ideas??



Ron

Fixed the link in first post. Here it is...points to my article a ways back on the board I had done. Many ways to make this. Important thing is to have it straight and STAY straight over time! I am still to this day using that old board! I made a couple similar boards that I use to build riggers on. Those are made with 5/8" melamine board. Glue is easy to remove from them should you have to. www.modelgasboats.com/Setup_Board/